Juniper EX Series User Manual

Table 72: RIP Routing Configuration Summary (continued)
Your ActionFunctionField
Click Add to add an export policy.
Click Move up or Move down to move the
selected policy up or down the list of policies.
Click Remove to remove an export policy.
Applies a policy to routes being exported to the
neighbors.
Export Policy
Neighbors tab
To enable RIP on an interface, click the check
box next to the interface name.
Click Edit if you want to modify an interface’s
settings.
Selects the interfaces to be associated with
the RIP instance.
RIP-Enabled Interfaces
Table 73: Edit RIP Global Settings
Your ActionFunctionField
General tab
Select a value.Specifies RIP send options.Send
Select a value.Configure RIP receive options.Receive
Type a value.Specifies the route timeout interval for RIP.Route timeout (sec)
Type or select and edit the value.Specifies the update time interval to periodically send out
routes learned by RIP to neighbors.
Update interval
(sec)
Type or select and edit the value.Specifies the time period the expired route is retained in
the routing table before being removed.
Hold timeout (sec)
Type or select and edit the value.Specifies the metric to add to incoming routes when
advertising into RIP routes that were learned from other
protocols.
Metric in
Select and edit the name of the routing
table group.
Specifies a routing table group to install RIP routes into
multiple routing tables.
RIB Group
Type or select and edit the value.Specifies the number of route entries to be included in
every RIP update message.
Message size
Copyright © 2017, Juniper Networks, Inc.146
J-Web Application Package User Guide for EX Series Switches, Release 14.1X53-A1

Juniper EX Series Specifications

General

Series	EX Series
Category	Switch
Layer	Layer 2/3
Operating System	Junos OS
Managed	Yes
ACLs	Yes
Port Density	Varies by model
Power over Ethernet (PoE)	Available on some models
Virtual Chassis	Supported on some models
Form Factor	Fixed configuration, Modular
Switching Capacity	Varies by model
Forwarding Rate	Varies by model
Power Supply	Varies by model (AC or DC, redundant options available)
Management	CLI, Web UI, SNMP
Redundancy	Power supply, fan, Virtual Chassis
Latency	Varies by model
Jumbo Frames	Supported
VLAN Support	Yes
MAC Address Table Size	Varies by model
QoS	Yes
Energy Efficiency	EEE (802.3az)
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0° to 45° C
Storage Temperature	-40° to 70° C
Humidity	5% to 90% non-condensing
MTBF	Varies by model
Warranty	Limited Lifetime