Juniper EX Series User Manual

Table 37: Schedulers Configuration Page (continued)
Your ActionFunctionField
To define a transmit rate, select the appropriate
option:
•
To enforce the exact transmission rate, select
Rate and enter a value.
•
To specify the remaining transmission
capacity, select Remainder Available.
•
To specify a percentage of transmission
capacity, select Percent and type an integer
from 1 through 100.
•
To specify no transmit rate, select the blank
check box.
Defines the transmission rate of a scheduler.
The transmit rate determines the traffic
bandwidth from each forwarding class you
configure.
By default, queues 0 through 11 are allotted the
following percentages of the transmission
capacity:
•
Queue 0—75 percent
•
Queue 1—0 percent
•
Queue 2—0 percent
•
Queue 3—5 percent
•
Queue 4—0 percent
•
Queue 5—0 percent
•
Queue 6—0 percent
•
Queue 7—0 percent
•
Queue 8—15 percent
•
Queue 9—0 percent
•
Queue 10—0 percent
•
Queue 11—5 percent
Transmit rate
To define the excess rate, select the appropriate
option:
•
To specify a percentage of the excess rate,
select Percent and type an integer from 1
through 100.
•
To specify no excess rate, select the blank
check box.
Defines the excess rate of a scheduler.Excess rate
NOTE: This option is
supported only on EX4300
switches.
Related
Documentation
Defining CoS Schedulers and Scheduler Maps (CLI Procedure)•
• Example: Configuring CoS on EX Series Switches
• Monitoring CoS Scheduler Maps on page 232
Defining CoS Scheduler Maps (J-Web Procedure)
NOTE: This topic applies only to the J-Web Application package.
J-Web Application package Release 14.1X53-A2 does not support Class of
Service (CoS) for EX4600 switches.
You can use the J-Web interface to configure CoS scheduler maps on an EX Series switch.
71Copyright © 2017, Juniper Networks, Inc.
Chapter 5: Class of Service Configuration

Juniper EX Series Specifications

General

Brand	Juniper
Model	EX Series
Category	Switch
Language	English