Configuring Port Security (J-Web Procedure)
NOTE: This topic applies only to the J-Web Application package.
To configure port security on an EX Series switch using the J-Web interface:
1. Select Configure > Security > Port Security.
The VLAN List table lists all the VLAN names, VLAN identifiers, port members, and
port security VLAN features.
The Interface List table lists all the ports and indicates whether security features have
been enabled on the ports.
NOTE: After you make changes to the configuration on this page, you
must commit the changes for them to take effect. To commit all changes
to the active configuration, select Commit Options > Commit. See Using
the Commit Options to Commit Configuration Changes for details about
all commit options.
2. Click one of the following options:
•
Edit—Click this option to modify the security features for the selected port or VLAN.
Enter information as specified in Table 45 on page 80 to modify port security settings
on VLANs.
Enter information as specified in Table 46 on page 82 to modify port security settings
on interfaces.
•
Activate/Deactivate—Click this option to enable or disable security on the switch.
NOTE: This option is not supported on EX4300 switches.
•
Delete—Click this option to delete the security features of the selected port or VLAN.
NOTE: This option is supported only on EX4300 switches.
Table 45: Port Security Settings on VLANs
Your ActionFunctionField
General tab
Copyright © 2017, Juniper Networks, Inc.80
J-Web Application Package User Guide for EX Series Switches, Release 14.1X53-A1
To Next Page
Loading...
Need help?
General
