Juniper EX Series User Manual

Related
Documentation
Configuring SNMP (J-Web Procedure) on page 131•
• Viewing Real-Time Performance Monitoring Information on page 158
Viewing Real-Time Performance Monitoring Information
NOTE: This topic applies only to the J-Web Application package.
Real-time performance monitoring (RPM) on EX Series switches enables you to configure
and send probes to a specified target and monitor the analyzed results to determine
packet loss, round-trip time, and jitter. The J-Web interface provides a graphical view of
RPM information for EX Series switches.
To view the RPM information using the J-Web interface:
1. Select Troubleshoot >RPM >View RPM.
2. Select the Round Trip Time check box to display the graph with round-trip time
included. Clear the check-box to view the graph without the round-trip time.
3. From the Refresh Time list, select a refresh time interval for the graph.
Related
Documentation
• Configuring Real-Time Performance Monitoring (J-Web Procedure) on page 151
Copyright © 2017, Juniper Networks, Inc.158
J-Web Application Package User Guide for EX Series Switches, Release 14.1X53-A1

Juniper EX Series Specifications

General

Series	EX Series
Category	Switch
Layer	Layer 2/3
Operating System	Junos OS
Managed	Yes
ACLs	Yes
Port Density	Varies by model
Power over Ethernet (PoE)	Available on some models
Virtual Chassis	Supported on some models
Form Factor	Fixed configuration, Modular
Switching Capacity	Varies by model
Forwarding Rate	Varies by model
Power Supply	Varies by model (AC or DC, redundant options available)
Management	CLI, Web UI, SNMP
Redundancy	Power supply, fan, Virtual Chassis
Latency	Varies by model
Jumbo Frames	Supported
VLAN Support	Yes
MAC Address Table Size	Varies by model
QoS	Yes
Energy Efficiency	EEE (802.3az)
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0° to 45° C
Storage Temperature	-40° to 70° C
Humidity	5% to 90% non-condensing
MTBF	Varies by model
Warranty	Limited Lifetime