Juniper EX Series - Virtual Chassis Configuration; Configuring a Virtual Chassis on an EX Series Switch (J-Web Procedure); Configuring an EX2200, EX2200-C, EX3300, EX4200, EX4300, EX4500, EX4550, or EX4600 Virtual Chassis (J-Web Procedure)

Table 76: Performance Probe Tests Configuration Fields (continued)
Your ActionFunctionField
•
To enable SNMP traps for this
condition, select the check box.
•
To disable SNMP traps, clear the check
box.
Generates SNMP traps when the
threshold for maximum outbound time
is exceeded.
Egress Time Exceeded
•
To enable SNMP traps for this
condition, select the check box.
•
To disable SNMP traps, clear the check
box.
Generates SNMP traps when the
threshold for jitter in inbound time is
exceeded.
Ingress Jitter Exceeded
•
To enable SNMP traps for this
condition, select the check box.
•
To disable SNMP traps, clear the check
box.
Generates SNMP traps when the
threshold for standard deviation in
inbound times is exceeded.
Ingress Standard Deviation Exceeded
•
To enable SNMP traps for this
condition, select the check box.
•
To disable SNMP traps, clear the check
box.
Generates SNMP traps when the
threshold for maximum inbound time is
exceeded.
Ingress Time Exceeded
•
To enable SNMP traps for this
condition, select the check box.
•
To disable SNMP traps, clear the check
box.
Generates SNMP traps when the
threshold for jitter in round-trip time is
exceeded.
Jitter Exceeded
•
To enable SNMP traps for this
condition, select the check box.
•
To disable SNMP traps, clear the check
box.
Generates SNMP traps when the
threshold for the number of successive
lost probes is exceeded.
Probe Failure
•
To enable SNMP traps for this
condition, select the check box.
•
To disable SNMP traps, clear the check
box.
Generates SNMP traps when the
threshold for maximum round-trip time
is exceeded.
RTT Exceeded
•
To enable SNMP traps for this
condition, select the check box.
•
To disable SNMP traps, clear the check
box.
Generates SNMP traps when the
threshold for standard deviation in
round-trip times is exceeded.
Standard Deviation Exceeded
•
To enable SNMP traps for this
condition, select the check box.
•
To disable SNMP traps, clear the check
box.
Generates SNMP traps when a test is
completed.
Test Completion
•
To enable SNMP traps for this
condition, select the check box.
•
To disable SNMP traps, clear the check
box.
Generates SNMP traps when the
threshold for the total number of lost
probes is exceeded.
Test Failure
157Copyright © 2017, Juniper Networks, Inc.
Chapter 12: Configuring Real-Time Performance Monitoring