CHAPTER 5
Class of Service Configuration
•
Defining CoS Drop Profiles (J-Web Procedure) on page 59
•
Defining CoS Classifiers (J-Web Procedure) on page 60
•
Defining CoS Code-Point Aliases (J-Web Procedure) on page 62
•
Assigning CoS Components to Interfaces (J-Web Procedure) on page 64
•
Defining CoS Forwarding Classes (J-Web Procedure) on page 65
•
Defining CoS Rewrite Rules (J-Web Procedure) on page 67
•
Defining CoS Schedulers (J-Web Procedure) on page 69
•
Defining CoS Scheduler Maps (J-Web Procedure) on page 71
Defining CoS Drop Profiles (J-Web Procedure)
NOTE: This topic applies only to the J-Web Application package.
J-Web Application package Release 14.1X53-A2 does not support Class of
Service (CoS) on EX4600 switches.
You can use the J-Web interface to define CoS drop profiles on EX4500 and EX8200
switches.
To configure CoS drop profiles:
1. Select Configure > Class of Service > Drop Profile.
NOTE: After you make changes to the configuration on this page, you
must commit the changes immediately for them to take effect. To commit
all changes to the active configuration, select Commit Options > Commit.
See “Using the Commit Options to Commit Configuration Changes (J-Web
Procedure)” on page 31 for details about all commit options.
2. Select one of the following options:
59Copyright © 2017, Juniper Networks, Inc.
To Next Page
Loading...
Need help?
General
