Juniper EX4200

CHAPTER 12
Installing the Switch
•
Installing and Connecting an EX4200 Switch on page 157
•
Mounting an EX4200 Switch on page 158
•
Mounting an EX4200 Switch on a Desk or Other Level Surface on page 159
•
Mounting an EX4200 Switch on Two Posts in a Rack or Cabinet on page 160
•
Mounting an EX4200 Switch on Four Posts in a Rack or Cabinet on page 163
•
Mounting an EX4200 Switch in a Recessed Position in a Rack or Cabinet on page 166
•
Mounting an EX4200 Switch on a Wall on page 167
•
Installing and Removing EX4200 Switch Hardware Components on page 169
Installing and Connecting an EX4200 Switch
The EX4200 switch chassis is a rigid sheet-metal structure that houses the hardware
components.
To install and connect an EX4200 switch:
1. Follow instructions in “Unpacking an EX4200 Switch” on page 153.
2. Install a power supply if it is not pre-installed; see “Installing a Power Supply in an
EX4200 Switch” on page 211.
3. Install a fan tray if it is not pre-installed; see “Installing a Fan Tray in an EX4200 Switch”
on page 207.
4. Mount the switch by following instructions appropriate for your site:
•
“Mounting an EX4200Switch on Two Postsin a Rack or Cabinet” on page 160 (using
the mounting brackets provided)
•
“Mounting an EX4200 Switch on Four Posts in a Rack or Cabinet” on page 163 (using
the separately orderable four-post rack-mount kit)
•
“Mounting an EX4200 Switch in a Recessed Position in a Rack or Cabinet” on page 166
(using the 2-in.-recess front brackets from the separately orderable four-post
rack-mount kit)
157Copyright © 2015, Juniper Networks, Inc.