Juniper EX4200 User Manual

CHAPTER 21
Replacing a Member Switch to Virtual
Chassis
•
Adding a New EX4200 Switch to an Existing EX4200 Virtual Chassis (CLI
Procedure) on page 231
•
Replacing a Member Switch of a Virtual Chassis Configuration (CLI
Procedure) on page 236
Adding a New EX4200 Switch to an Existing EX4200 Virtual Chassis (CLI Procedure)
This topic explains how to add an EX4200 switch to an existing EX4200 Virtual Chassis.
For information about adding an EX4200 switch to an EX4500 Virtual Chassis or a mixed
Virtual Chassis, see Adding an EX4200 Switch to a Preprovisioned EX4500 Virtual Chassis
or a Preprovisioned Mixed EX4200 and EX4500 Virtual Chassis (CLI Procedure).
To add an EX4200 switch to an existing EX4200 Virtual Chassis, use the procedure that
matches what you need to accomplish:
•
Adding a New Switch to an Existing Virtual Chassis Within the Same Wiring
Closet on page 231
•
Adding a New Switch from a Different Wiring Closet to an Existing Virtual
Chassis on page 233
•
Adding a New Switch to an Existing Preprovisioned Virtual Chassis Using
Autoprovisioning on page 234
Adding a New Switch to an Existing Virtual Chassis Within the Same Wiring Closet
This procedure can be used to add an EX4200 switch to an EX4200 Virtual Chassis.
Before you begin, be sure you have:
•
Mounted the new switch in a rack.
•
Confirmed that the new switch is powered off.
•
If you are expanding a preprovisioned configuration, made a note of the serial number
(the number is on the back of the switch). You will need to edit the Virtual Chassis
configuration to include the serial number of the new member switch.
231Copyright © 2015, Juniper Networks, Inc.

Juniper EX4200 Specifications

General

Model	EX4200
Switching Capacity	128 Gbps
Layer	Layer 2 and Layer 3
Form Factor	1U
Throughput	96 Mpps
Maximum VLANs	4096
MAC Address Table Size	16, 000
DRAM	1 GB
Flash Memory	1 GB
Forwarding Rate	96 Mpps
JUNOS Software	Yes
Ports	24 or 48
Stacking	Up to 10 switches in a Virtual Chassis configuration
Power Supply	AC or DC
Management	CLI, SNMP, J-Web
Input Voltage	100-240 VAC or -48 VDC
Operating Temperature	0°C to 45°C
Redundancy	Redundant power supplies
Virtual Chassis Technology	Yes
Storage Temperature	-40°C to 70°C
Humidity	5% to 90% non-condensing