Juniper EX4200 User Manual

Table 39: Optical interface Support and Copper Interface Support for Gigabit Ethernet SFP
Transceivers in EX4200 Switches
ValueSpecificationEthernet Standard
EX-SFP-1GE-TModel number1000BASE-T
10/100/1000 MbpsRate
RJ-45Connector type
CopperFiber count
–Transmitter wavelength
–Minimum launch power
–Maximum launch power
–Minimum receiver sensitivity
–Maximum input power
CopperFiber type
–Core/Cladding size
–Modal bandwidth
100 m (328 ft)Distance
Not availableDOM support
EX4200-24T, EX4200-24T-DC, EX4200-24P, EX4200-24PX,
EX4200-24F, EX4200-24F-DC, EX4200-48T, EX4200-48T-DC,
EX4200-48P, and EX4200-48PX switches—Junos OS for
EX Series switches, Release 9.0 or later
EX4200-24F-S and EX4200-48T-S switches—Junos OS for
EX Series switches, Release 12.3R4 or later
Software required
NoSupport for Virtual Chassis
configuration
83Copyright © 2015, Juniper Networks, Inc.
Chapter 8: Transceiver and Cable Specifications

Juniper EX4200 Specifications

General

Model	EX4200
Switching Capacity	128 Gbps
Layer	Layer 2 and Layer 3
Form Factor	1U
Throughput	96 Mpps
Maximum VLANs	4096
MAC Address Table Size	16, 000
DRAM	1 GB
Flash Memory	1 GB
Forwarding Rate	96 Mpps
JUNOS Software	Yes
Ports	24 or 48
Stacking	Up to 10 switches in a Virtual Chassis configuration
Power Supply	AC or DC
Management	CLI, SNMP, J-Web
Input Voltage	100-240 VAC or -48 VDC
Operating Temperature	0°C to 45°C
Redundancy	Redundant power supplies
Virtual Chassis Technology	Yes
Storage Temperature	-40°C to 70°C
Humidity	5% to 90% non-condensing