CHAPTER 31
Electrical Safety Guidelines and Warnings
•
General Electrical Safety Guidelines and Warnings on page 299
•
Action to Take After an Electrical Accident on page 300
•
Prevention of Electrostatic Discharge Damage on page 301
•
AC Power Electrical Safety Guidelines on page 303
•
AC Power Disconnection Warning on page 305
•
DC Power Electrical Safety Guidelines on page 306
•
DC Power Disconnection Warning on page 308
•
DC Power Grounding Requirements and Warning on page 309
•
DC Power Wiring Sequence Warning on page 310
•
DC Power Wiring Terminations Warning on page 312
•
Multiple Power Supplies Disconnection Warning on page 314
•
TN Power Warning on page 314
General Electrical Safety Guidelines and Warnings
This topic applies to hardware devices in the EX Series product family, which includes
EX Series switches, the EX Series Redundant Power System (RPS), and the XRE200
External Routing Engine.
This topic also applies to hardware devices in the QFX Series and to OCX1100 switches.
WARNING: Certain ports on the device are designed for use as intrabuilding
(within-the-building) interfaces only (Type 2 or Type 4 ports as described in
GR-1089-CORE) and require isolation from the exposed outside plant (OSP)
cabling. To comply with NEBS requirements and protect against lightning
surges and commercial power disturbances, the intrabuilding ports must not
be metallically connected to interfaces that connect to the OSP or its wiring.
The intrabuilding ports on the device are suitable for connection to
intrabuilding or unexposed wiring or cabling only. The addition of primary
protectors is not sufficient protection for connecting these interfaces
metallically to OSP wiring.
299Copyright © 2015, Juniper Networks, Inc.
To Next Page
Loading...
Need help?
General
