Juniper EX4200 User Manual

7. Place one hand under the power supply to support it and slide it completely out of
the chassis. Take care not to touch power supply components, pins, leads, or solder
connections.
8. Place the power supply in the antistatic bag or on the antistatic mat placed on a flat,
stable surface.
Figure 57: Removing a Power Supply from the Switch
Related
Documentation
• Installing a Power Supply in an EX4200 Switch on page 211
• Installing and Removing EX4200 Switch Hardware Components on page 169
• Power Supply in EX4200 Switches on page 33
• Field-Replaceable Units in EX4200 Switches on page 10
• AC Power Cord Specifications for EX4200 Switches on page 76
• Rear Panel of an EX4200 Switch on page 12
Copyright © 2015, Juniper Networks, Inc.214
EX4200 Switch Hardware Guide

Juniper EX4200 Specifications

General

Model	EX4200
Switching Capacity	128 Gbps
Layer	Layer 2 and Layer 3
Form Factor	1U
Throughput	96 Mpps
Maximum VLANs	4096
MAC Address Table Size	16, 000
DRAM	1 GB
Flash Memory	1 GB
Forwarding Rate	96 Mpps
JUNOS Software	Yes
Ports	24 or 48
Stacking	Up to 10 switches in a Virtual Chassis configuration
Power Supply	AC or DC
Management	CLI, SNMP, J-Web
Input Voltage	100-240 VAC or -48 VDC
Operating Temperature	0°C to 45°C
Redundancy	Redundant power supplies
Virtual Chassis Technology	Yes
Storage Temperature	-40°C to 70°C
Humidity	5% to 90% non-condensing