Juniper EX4200

5. Ensure that the other holes in the mounting brackets are aligned with the holes in the
side panels. Insert a screw in each hole and tighten the screws.
6. Have one person grasp both sides of the switch, lift the switch, and position it in the
rack, aligning the mounting bracket holes with the threaded holes in the rack or cabinet
rail. Align the bottom hole in both the mounting brackets with a hole in each rack rail,
making sure the chassis is level. See Figure 32 on page 162.
Figure 32: Mounting the Switch on Two Posts in a Rack
g020094
Mounting rack
Mounting bracket
7. Have a second person secure the switch to the rack by using the appropriate screws.
Tighten the screws.
8. Ensure that the switch chassis is level by verifying that all screws on one side of the
rack are aligned with the screws on the other side.
NOTE: If the switch is an EX4200-24F model, we recommend that you insert
dust covers in any unused SFP ports.
Related
Documentation
Connecting Earth Ground to an EX Series Switch on page 171•
• Connecting AC Power to an EX4200 Switch on page 177
• Connecting DC Power to an EX4200 Switch on page 179
• Connecting and Configuring an EX Series Switch (CLI Procedure) on page 195
• Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 198
• Mounting an EX4200 Switch in a Recessed Position in a Rack or Cabinet on page 166
• Rack-Mounting and Cabinet-Mounting Warnings on page 280
Copyright © 2015, Juniper Networks, Inc.162
EX4200 Switch Hardware Guide