Juniper EX4200

• Mounting an EX8208 Switch on a Rack or Cabinet
• Mounting an EX8216 Switch on a Rack or Cabinet
• Mounting an EX9200 Switch on a Rack or Cabinet Using a Mechanical Lift
• Mounting an EX9204 Switch on a Rack or Cabinet Without Using a Mechanical Lift
• Mounting an EX9208 Switch on a Rack or Cabinet Without Using a Mechanical Lift
• Mounting an OCX1100 Switch
• Mounting a QFX3100 Director Device on Four Posts in a Rack or Cabinet
• Mounting a QFX3100 Director Device on Two Posts in a Rack or Cabinet
• Mounting a QFX3008-I Interconnect Device on a Rack or Cabinet Using a Mechanical
Lift
• Mounting a QFX3600 or QFX3600-I Device on Four Posts in a Rack or Cabinet
• Mounting a QFX3600 or QFX3600-I Device on Two Posts in a Rack or Cabinet
• Mounting a QFX3500 Device in a Rack or Cabinet
• Mounting a QFX5100 Device in a Rack or Cabinet
Wall-Mounting Warning for EX4200 Switches
WARNING: When mounted in a vertical position, an EX3200 or EX4200
chassis must be oriented with the front panel of the chassis pointing down
to ensure proper airflow and meet safety requirements in the event of a fire.
WARNING: Avertissement: lorsqu’installé en position verticale, un châssis
de commutation EX3200 ou EX4200 doit être orienté avec le panneau avant
dirigé vers le bas.
WARNING: Warnhinweis: Bei der Befestigung in vertikaler Position muss ein
EX3200- oder EX4200-Switch-Gehäuse so ausgerichtet werden, dass das
vordere Bedienfeld des Switch-Gehäuses nach unten zeigt.
Related
Documentation
Mounting an EX4200 Switch on a Wall on page 167•
Grounded Equipment Warning
This topic applies to hardware devices in the EX Series product family, which includes
EX Series switches, the EX Series Redundant Power System (RPS), and the XRE200
External Routing Engine.
Copyright © 2015, Juniper Networks, Inc.284
EX4200 Switch Hardware Guide