Juniper EX4200 User Manual

user@switch> set chassis display message message fpc-slot slot-number
To display a custom message permanently:
•
On an EX3200 switch, a standalone EX3300 switch, a standalone EX4200 switch, a
standalone EX4300 switch, a standalone EX4500 switch, a standalone EX4550 switch,
an EX6200 switch, an EX8200 switch, or an XRE200 External Routing Engine:
user@switch> set chassis display message message permanent
•
On an EX3300, EX4200, EX4300, EX4500, or EX4550 switch in a Virtual Chassis
configuration:
user@switch> set chassis display message message fpc-slot slot-number permanent
NOTE: The buttonson the LCD panelare disabledwhen the LCD isconfigured
to display a custom message.
To disable the display of the custom message:
user@switch> clear chassis display message
You can view the custom message by issuing the show chassis lcd command.
Related
Documentation
• LCD Panel in EX3200 Switches
• LCD Panel in EX3300 Switches
• LCD Panel in EX4200 Switches on page 13
• LCD Panel in EX4300 Switches
• LCD Panel in EX4500 Switches
• LCD Panel in EX4550 Switches
• LCD Panel in an EX6200 Switch
• LCD Panel in an EX8200 Switch
• LCD Panel in an XRE200 External Routing Engine
203Copyright © 2015, Juniper Networks, Inc.
Chapter 15: Performing Initial Configuration

Juniper EX4200 Specifications

General

Model	EX4200
Switching Capacity	128 Gbps
Layer	Layer 2 and Layer 3
Form Factor	1U
Throughput	96 Mpps
Maximum VLANs	4096
MAC Address Table Size	16, 000
DRAM	1 GB
Flash Memory	1 GB
Forwarding Rate	96 Mpps
JUNOS Software	Yes
Ports	24 or 48
Stacking	Up to 10 switches in a Virtual Chassis configuration
Power Supply	AC or DC
Management	CLI, SNMP, J-Web
Input Voltage	100-240 VAC or -48 VDC
Operating Temperature	0°C to 45°C
Redundancy	Redundant power supplies
Virtual Chassis Technology	Yes
Storage Temperature	-40°C to 70°C
Humidity	5% to 90% non-condensing