EasyManuals Logo

KAESER SIGMA CONTROL 2 Service Manual

KAESER SIGMA CONTROL 2
184 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #146 background imageLoading...
Page #146 background image
Switching on
Precondition The fault has been rectified
1. Turn the EMERGENCY STOP command device in the direction of the arrow to unlatch it.
2. Acknowledge any existing alarm messages.
Result The machine can now be started again.
9.3 Acknowledging alarm and warning messages
Messages are displayed on the "new value" principle. You can acknowledge warning or fault mes‐
sages immediately after
Message coming
or
Message going
. However, warning and fault messag‐
es can be acknowledged only following a successful elimination of the corresponding fault.
Message sequence 1 Display
Message coming LED flashes
Message acknowledged LED illuminates
Message going LED off
Tab. 84 Message sequence 1
Message sequence 2 Display
Message coming LED flashes
Message going LED flashes
Message acknowledged LED off
Tab. 85 Message sequence 2
Fig. 35 Acknowledging messages
17
Warning
LED (yellow)
20
Alarm
LED (red)
21 «Acknowledge» key
Fault message
A fault message shuts the machine down automatically.
The red
Fault
LED flashes.
Precondition The fault has been rectified
9 Operation
9.3 Acknowledging alarm and warning messages
136
Service Manual Controller
SIGMA CONTROL 2 BLOWER ≥ 2.5.3 No.: 901700 10 E

Table of Contents

Other manuals for KAESER SIGMA CONTROL 2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the KAESER SIGMA CONTROL 2 and is the answer not in the manual?

KAESER SIGMA CONTROL 2 Specifications

General IconGeneral
Controller TypeMicroprocessor-based
ModelSIGMA CONTROL 2
ManufacturerKAESER
Input Voltage24 V DC
Protection ClassIP54
Communication ProtocolsModbus, Profibus
Data LoggingComprehensive data logging
Remote MonitoringYes
Communication InterfaceEthernet