➤ Press the «Acknowledgement» key to acknowledge the fault message.
Alarm
LED extinguishes. The machine is ready to start again.
The machine has been stopped with the EMERGENCY STOP command device.
➤ First turn the EMERGENCY STOP command device in the direction of the arrow to un‐
lock it.
➤ Then acknowledge the fault message.
Further information A list of possible fault messages occurring during operation are shown in chapter 10.2.
Warning message
If maintenance work is to be carried out or if the warning is displayed before a fault, the yel‐
low
warning
LED flashes.
Precondition The risk of a fault has been eliminated
Maintenance has been carried out
➤ Press the «Acknowledgement» key to acknowledge the warning message.
The
Maintenance
LED extinguishes. The machine is ready to start again.
Further information A list of possible warning messages occurring during operation are shown in chapter 10.3.
9.4 Displaying messages
The following information can be accessed in the 1.1
<Status – Messages>
menu:
■ Current messages
─ Last alarm
─ Last warning
─ Number of currently registered fault and/or warnings
■ Messages history: The last 1000 events, these include fault and warning messages
─ Blower messages
─ Diagnostic messages
─ System messages
The information (message) is shown in three lines of the display.
Line Submenu/Segment/Text
1 Selected submenu:
■ Blower messages
■ Diagnostic messages
■ System messages
2 Segment:
■ Message number
■ Type of message
■ Message status
■ Message date
■ Message time
9 Operation
9.4 Displaying messages
No.: 901700 10 E
Service Manual Controller
SIGMA CONTROL 2 BLOWER ≥ 2.5.3
137
To Next Page
Loading...
Need help?
General