KAESER SIGMA CONTROL 2 Service Manual

Format Example
°F 114°F
Tab. 54 Possible settings for the temperature unit
Precondition Access level 2 is activated.
1. Open the 5.1 <Configuration – General> menu.
2. Use «Up» or «Down» to select the Temperature unit line.
4 0 0 m b a r 0 8 : 1 5 A M 8 0 ° C
Header
5.1 General
Menu
Time format hh:mm:ssAM/PM
······························
Pressure unit bar
Unit of pressure
Temperature unit °C
Unit of temperature
······························
Display illumination
3. Press «Enter».
The display for the set unit flashes.
4. Use «Up» or «Down» to set the unit.
5. Press «Enter».
The setting is applied.
6. Press «Escape» repeatedly to leave this menu.
8.2.11 Setting the display illumination
Set the display lighting mode:
Mode 1 2 3
Indication automatic on off
Function The illumination extin‐
guishes after the time-
out has elapsed.
Permanent setting
Illumination "on"
Permanent setting
Illumination "off"
Tab. 55 Display illumination
Precondition Access level 2 is activated.
1. Open the 5.1 <Configuration – General> menu.
2. Use «Up» or «Down» to select the Display illumination line.
8 Initial Start-up
8.2 Setting the controller
60
Service Manual Controller
SIGMA CONTROL 2 BLOWER ≥ 2.5.3 No.: 901700 10 E

KAESER SIGMA CONTROL 2 Specifications

General

Controller Type	Microprocessor-based
Model	SIGMA CONTROL 2
Manufacturer	KAESER
Input Voltage	24 V DC
Protection Class	IP54
Communication Protocols	Modbus, Profibus
Data Logging	Comprehensive data logging
Remote Monitoring	Yes
Communication Interface	Ethernet