Secure storage of the RFID Equipment Cards
You will receive 2 RFID Equipment Cards with each machine.
They are stored in a plastic sleeve.
This plastic sleeve is attached at the rear of the controller in the control cabinet.
If you lose both RFID Equipment Cards, you can register a new RFID Equipment Card only after
having entered the user name and the password. A new RFID Equipment Card may be registered
by the KAESER Service subject to a fee, if the user name and the password are lost.
5.6 KAESER CONNECT
Using an Internet-capable device with web browser, you can open a visualisation of the controller.
This enables remote checking of, for example, the operating and energy efficiency of your ma‐
chine. For this purpose, you must generate a password once (see Chapter 8.2.5). KAESER
CONNECT does not require additional software to do so. The display language of KAESER
CONNECT can be set independently to the language used with SIGMA CONTROL 2.
Fig. 9 KAESER CONNECT for SIGMA CONTROL 2
KAESER CONNECT functions:
Operating element Meaning
read => write Switching from read-only to read/write mode
To create users and acknowledge messages
write => read Switching from read/write to read-only mode
Logout Log out user
Contact/Service Displaying the contact information for KAESER SERVICE
12)
not for SXC
5 Design and Function
5.6 KAESER CONNECT
28
Service Manual Controller
SIGMA CONTROL 2 BLOWER ≥ 2.5.3 No.: 901700 10 E
To Next Page
Loading...
Need help?
General