KAESER SIGMA CONTROL 2 Service Manual

3. Press «Enter».
The currently set language flashes.
4. Use «Up» or «Down» to select the desired language.
5. Press «Enter».
Result The user interface is displayed in the set language.
8.2.3 Noting the user name
The number on the back of your RFID Equipment Card is identical to the user name dis‐
played on SIGMA CONTROL 2 after you have successfully logged on using your
RFID Equipment Card.
Fig. 12 Back of the RFID Equipment Card
1 Back of the RFID Equipment Card
2 Number of the RFID Equipment Card
1. Note the user name (= number of the RFID Equipment Card).
2. Keep the note at a secure location.
If your RFID Equipment Card gets damaged or can no longer be found?
➤ If you know your user name and password, you can manually log on to
SIGMA CONTROL 2 (see chapter 8.2.5).
8.2.4 User log-on with RFID Equipment Card
The RFID Equipment Card enables you to easily and quickly log on at SIGMA CONTROL 2. It au‐
thorises you to access advanced functions of the controller.
Advanced access rights allow you to:
■ Read additional data
■ Change other settings
Fig. 13 User log-on with RFID Equipment Card
8 Initial Start-up
8.2 Setting the controller
No.: 901700 10 E
Service Manual Controller
SIGMA CONTROL 2 BLOWER ≥ 2.5.3
51

KAESER SIGMA CONTROL 2 Specifications

General

Controller Type	Microprocessor-based
Model	SIGMA CONTROL 2
Manufacturer	KAESER
Input Voltage	24 V DC
Protection Class	IP54
Communication Protocols	Modbus, Profibus
Data Logging	Comprehensive data logging
Remote Monitoring	Yes
Communication Interface	Ethernet