7 Installation
7.1 Reporting Transport Damage
1. Check the machine for visible and hidden transport damage.
2. Inform the carrier and the manufacturer in writing of any damage without delay.
7.2 Machine identification
If the machine is run in sequenced operation its identification as detailed in the installation diagram
is to be taken into account.
Identifying the machine for operation in remote mode.
➤ Attach the following notice to warn of remote machine operation (suggestion):
Remote control: Risk of injury caused by unexpected starting!
➤ Make sure the power supply disconnecting device is switched off before commencing any
work on the machine.
Tab. 47 Machine identification
➤ Label the starting device in the remote control centre as follows (suggestions):
Remote control: Risk of injury caused by unexpected starting!
➤ Before starting, make sure that no one is working on the machine and that it can be safely
started.
Tab. 48 Remote control identification
Identifying the machine for time control (clock mode operation)
➤ Attach the following notice to indicate the ON/OFF timer program machine operation (sugges‐
tion):
Time control: Risk of injury caused by unexpected starting!
➤ Make sure the power supply disconnecting device is switched off before commencing any
work on the machine.
Tab. 49 Machine identification
7 Installation
7.1 Reporting Transport Damage
No.: 901700 10 E
Service Manual Controller
SIGMA CONTROL 2 BLOWER ≥ 2.5.3
47
To Next Page
Loading...