KAESER SIGMA CONTROL 2 Service Manual

The following functions are not implemented with KAESER CONNECT:
■ Remotely starting the machine
■ Remotely setting parameters
For KAESER CONNECT to be able to use the Internet-capable device, it must be registered
in the same network as SIGMA CONTROL 2.
To be able to use KAESER CONNECT, the browser installed on the Internet-capable device
must be able to display HTML5 content. For security reasons, we strongly recommend to use
only up-to-date browser versions.
8.3.1 Open KAESER CONNECT
Precondition The user name (see chapter 8.2.3) and password (see chapter 8.2.5) are known.
The controller's IP address is known, see chapters 8.2.14 and 8.7.4.
1. Use an Ethernet cable to connect SIGMA CONTROL 2 to the Internet-capable device or net‐
work.
2. In the web browser, enter the IP address of the controller.
The log-in mask is displayed.
Fig. 16 Log-in mask
3. Enter your user name in the User name: field.
4. Enter your password in the Password: field.
5. Click Login.
KAESER CONNECT for SIGMA CONTROL 2 is displayed.
8 Initial Start-up
8.3 KAESER CONNECT benefits
68
Service Manual Controller
SIGMA CONTROL 2 BLOWER ≥ 2.5.3 No.: 901700 10 E

KAESER SIGMA CONTROL 2 Specifications

General

Controller Type	Microprocessor-based
Model	SIGMA CONTROL 2
Manufacturer	KAESER
Input Voltage	24 V DC
Protection Class	IP54
Communication Protocols	Modbus, Profibus
Data Logging	Comprehensive data logging
Remote Monitoring	Yes
Communication Interface	Ethernet