KAESER SIGMA CONTROL 2 - Timer

Message Meaning
0014 O
Restart lock-out active
The restart inhibitor is still activated. Wait until the blow‐
er starts
0027 O
Power OFF → ON
The control has been switched on
0038 O
Drag indicator p1 ⇟
Pressure peaks in the vacuum network
0039 O
Drag indicator p2 ⇞
Pressure peaks in the compressed air network
0073 O
External message 1
1)
0074 O
External message 2
1)
0075 O
External message 3
1)
0080 O
Vibration monitoring VSE ↑
Warning from vibration monitoring
0081 O
Vibration monitoring sum signal ⇡
Increased vibration values
0092 O
Switch p1
1)
0093 O
Switch p2
1)
0094 O
Switch T1
1)
0095 O
Switch T2
1)
0096 O
Switch block speed
1)
0097 O
Switch T3
1)
0098 O
Switch T_S
1)
0300 O
Cycle-exact data recording active
Service information
1000 O
2 RFID Equipment Cards successfully
registered
You successfully registered 2 RFID Equipment Cards at
the controller.
Tab. 96 Operational messages
10 Fault Recognition and Rectification
10.4 Interpreting operation messages
No.: 901700 10 E
Service Manual Controller
SIGMA CONTROL 2 BLOWER ≥ 2.5.3
161