KAESER SIGMA CONTROL 2 Service Manual

Precondition Access level 2 is activated.
1. Open the 5.1 <Configuration – General> menu.
2. Use «Up» or «Down» to select the Date format line.
4 0 0 m b a r 0 8 : 1 5 A M 8 0 ° C
Header
5.1 General
Menu
Europe/London
······························
▶2 Time server
······························
Date format MM/DD/YY
Date format
Time format hh:mm:ssAM/PM
3. Press «Enter».
The MM/DD/YY display flashes.
4. Use «Up» or «Down» to set the date format.
5. Press «Enter».
The setting is applied.
6. Press «Escape» repeatedly to leave this menu.
Setting the time format
Set the display for the time format:
Format Example
hh:mm:ss 13:33:45
hh:mm 13:33
hh:mm:ssAM/PM 01:33:45PM
hh:mmAM/PM 01:33PM
Tab. 52 Possible settings for the time format
Precondition Access level 2 is activated.
1. Open the 5.1 <Configuration – General> menu.
2. Use «Up» or «Down» to select the Time format line.
4 0 0 m b a r 0 8 : 1 5 A M 8 0 ° C
Header
5.1 General
Menu
Europe/London
······························
▶2 Time server
······························
Date format MM/DD/YY
Time format hh:mm:ssAM/PM
time format
3. Press «Enter».
The hh:mm:ssAM/PM indication flashes.
8 Initial Start-up
8.2 Setting the controller
58
Service Manual Controller
SIGMA CONTROL 2 BLOWER ≥ 2.5.3 No.: 901700 10 E

KAESER SIGMA CONTROL 2 Specifications

General

Controller Type	Microprocessor-based
Model	SIGMA CONTROL 2
Manufacturer	KAESER
Input Voltage	24 V DC
Protection Class	IP54
Communication Protocols	Modbus, Profibus
Data Logging	Comprehensive data logging
Remote Monitoring	Yes
Communication Interface	Ethernet