KAESER SIGMA CONTROL 2 Service Manual

A suitable transponder is the RFID Equipment Card. Two of them have been provided with the ma‐
chine.
Typical application:
■ Operators log on at the machine.
(Manual input of the password not required)
The RFID Equipment Cards are carefully packed in a plastic sleeve.
This plastic sleeve is attached to the rear of the controller in the control cabinet.
Fig. 7 RFID reader
Position Designation Function
24 RFID RFID reader for the communication with a RFID Equipment Card or RFID
Key.
Tab. 36 RFID reader
5.4 Display
Use the display to read information and to check entered data. The display comprises 8 lines, each
of 30 characters.
During operation, the operation mode is displayed as a pipe and instrument diagram.
Press «Enter» or one of the arrow keys to open the main menu. Here, you can set the language to
be used for the display of texts or open the various submenus.
5 Design and Function
5.4 Display
24
Service Manual Controller
SIGMA CONTROL 2 BLOWER ≥ 2.5.3 No.: 901700 10 E

KAESER SIGMA CONTROL 2 Specifications

General

Controller Type	Microprocessor-based
Model	SIGMA CONTROL 2
Manufacturer	KAESER
Input Voltage	24 V DC
Protection Class	IP54
Communication Protocols	Modbus, Profibus
Data Logging	Comprehensive data logging
Remote Monitoring	Yes
Communication Interface	Ethernet