3. Press the «DOWN» key.
The
Mode
line is displayed.
4 0 0 m b a r 0 8 : 1 5 A M 8 0 ° C
Header
5.1 General
Menu
······························
Pressure unit bar
Unit of pressure
Temperature unit °C
Unit of temperature
······························
Display illumination
Mode auto.¦ Timeout: 1min
Active line
4. Press «Enter».
The display for the set mode flashes.
5. Use the «Up» or «Down» keys to set the
auto.
mode.
6. Press «Enter».
The setting is applied.
7. Press the «Right» key.
8. Set the value for the
Timeout
in the same manner: 1 min, for example.
9. Press «Enter».
10. Press «Escape» repeatedly to leave this menu.
Result The display illumination is set for automatic operation with deactivation after one minute without
user intervention.
8.2.12 Setting the contrast and the brightness
Contrast and brightness are factory set to normal light conditions. You can manually set contrast
and brightness for different lighting conditions.
Precondition The operating mode is displayed.
1. Press and hold the «Information» key.
2. Use «Up» or «Down» to set the contrast.
3. Use «Left» or «Right» to set the brightness.
Result Contrast and brightness are set.
8.2.13 Activating the remote control
The «remote control» key on the operating panel of the SIGMA CONTROL 2 can be activated or
deactivated. Various menus offer check boxes for this setting.
Precondition Access level 2 is activated.
The operating mode is displayed.
1. Open the menu, e.g. 8
Communication
menu.
2. Use «Up» or «Down» to select the
Key remote
line.
8 Initial Start-up
8.2 Setting the controller
No.: 901700 10 E
Service Manual Controller
SIGMA CONTROL 2 BLOWER ≥ 2.5.3
61
To Next Page
Loading...
Need help?
General