KAESER SIGMA CONTROL 2 Service Manual

4. Use «Up» or «Down» to set the time format.
5. Press «Enter».
The setting is applied.
6. Press «Escape» repeatedly to leave this menu.
Setting the pressure display units
Set the pressure unit for display:
Format Example
bar 5.5bar
hPa 5523hPa
MPa 0.55MPa
psi 80psi
at 5.6at
"Hg 162"Hg
mbar 5500mbar
Tab. 53 Possible settings for the pressure unit
Precondition Access level 2 is activated.
1. Open the 5.1 <Configuration – General> menu.
2. Use «Up» or «Down» to select the Pressure unit line.
4 0 0 m b a r 0 8 : 1 5 A M 8 0 ° C
Header
5.1 General
Menu
Time format hh:mm:ssAM/PM
······························
Pressure unit bar
Unit of pressure
Temperature unit °C
Unit of temperature
······························
Display illumination
3. Press «Enter».
The display for the set unit flashes.
4. Use «Up» or «Down» to set the unit.
5. Press «Enter».
The setting is applied.
6. Press «Escape» repeatedly to leave this menu.
Setting the temperature display units
Set the temperature unit for display:
Format Example
°C 46°C
K 319K
8 Initial Start-up
8.2 Setting the controller
No.: 901700 10 E
Service Manual Controller
SIGMA CONTROL 2 BLOWER ≥ 2.5.3
59

KAESER SIGMA CONTROL 2 Specifications

General

Controller Type	Microprocessor-based
Model	SIGMA CONTROL 2
Manufacturer	KAESER
Input Voltage	24 V DC
Protection Class	IP54
Communication Protocols	Modbus, Profibus
Data Logging	Comprehensive data logging
Remote Monitoring	Yes
Communication Interface	Ethernet