4. Option W2/W3:
Detach the user connecting lines and use compressed air (<2 bar) to blow out the heat recov‐
ery system until liquid no longer escapes.
5. Properly close all open connecting ports.
13.2 Packing
➤ Follow the instructions in the machine's service manual.
13.3 Storage
➤ Follow the instructions in the machine's service manual.
13.4 Transporting
➤ Follow the instructions in the machine's service manual.
13.5 Battery removal and disposal
Precondition SIGMA CONTROL 2 is de-commissioned.
1. Disconnect SIGMA CONTROL 2 from all connections.
2. If necessary, use a tool to forcefully remove the rear enclosure panel.
3. If necessary, use a tool to forcefully remove the board from the housing.
4. Use a suitable tool to remove the internally installed battery.
5. Battery disposal in accordance with environmental guidelines.
6. Hand the SIGMA CONTROL 2 over to an authorised disposal expert.
Further information Refer to the machine’s Operating Manual for details regarding the battery’s environmentally sound
disposal.
13.5.1 Battery disposal in accordance with local environmental regulations.
Batteries contain substances that are harmful to living beings and the environment. For this reason,
batteries must not be disposed of with unsorted residential waste. They must be delivered to the
national battery collection system. This procedure facilitates the handling and recycling of batteries.
In EU Member States, as per Directive 2006/66 / EC, used batteries must be returned to the point
of sale or to a disposal system (free of charge). These disposal facilities may be local recycling
yards for used electric and electronic devices and their points of sale.
The SIGMA CONTROL 2controller’s enclosure houses a battery.
13 Decommissioning, Storage and Transport
13.2 Packing
No.: 901700 10 E
Service Manual Controller
SIGMA CONTROL 2 BLOWER ≥ 2.5.3
173
To Next Page
Loading...
Need help?
General