KAESER SIGMA CONTROL 2 Service Manual

3. Press the «DOWN» key.
4 0 0 m b a r 0 8 : 1 5 A M 8 0 ° C
Header
5.1 General
Menu
▶1 System information
Sub-menu
······························
Model: XXXXXX
set machine type (SC2 FLUID)
······························
Date/Time
04/13/20 08:15:37AM
current date and time
4. Press the «Right» key.
5. Press «Enter».
The display for hours 00:00:00 flashes.
6. Use «Up» or «Down» to set the hours.
7. Press the «Right» arrow.
The display for minutes 00:00:00 flashes.
8. Use «Up» or «Down» to set the minutes.
9. Press the «Right» arrow.
The display for seconds 00:00:00 flashes.
10. Use «Up» or «Down» to set the seconds.
11. Press «Enter».
The setting is applied.
12. Press «Escape» repeatedly to leave this menu.
Check/set the date
Precondition Access level 2 is activated.
1. Open the 5.1 <Configuration – General> menu.
2. Use «Up» or «Down» to select the Date/Time line.
3. Press the «DOWN» key.
4 0 0 m b a r 0 8 : 1 5 A M 8 0 ° C
Header
5.1 General
Menu
▶1 System information
Sub-menu
······························
Model: XXXXXX
set machine type (SC2 FLUID)
······························
Date/Time
04/13/20 08:15:37AM
current date and time
4. Press «Enter».
The display for days 00.00.00 flashes.
5. Use «Up» or «Down» to set the day.
6. Press the «Right» arrow.
The display for months 00.00.00 flashes.
8 Initial Start-up
8.2 Setting the controller
56
Service Manual Controller
SIGMA CONTROL 2 BLOWER ≥ 2.5.3 No.: 901700 10 E

KAESER SIGMA CONTROL 2 Specifications

General

Controller Type	Microprocessor-based
Model	SIGMA CONTROL 2
Manufacturer	KAESER
Input Voltage	24 V DC
Protection Class	IP54
Communication Protocols	Modbus, Profibus
Data Logging	Comprehensive data logging
Remote Monitoring	Yes
Communication Interface	Ethernet