7. Press «Enter».
The display for hours,
00:00
flashes.
8. Use «Up» or «Down» to set the hours.
9. Press the «Right» arrow.
10. The display for minutes, 00:
00
flashes.
11. Use «Up» or «Down» to set the minutes.
12. Press the «Enter» key.
The setting is applied.
4 0 0 m b a r 0 8 : 1 5 A M 8 0 ° C
Header
6 Time control
Menu
······························
01 Mon-Fri 06:30AM on
Switching point 01 is set
02 Mon-Fri 12:00PM off
Switching point 02 is set
03 Mon-Fri 01:00PM on
Switching point 03 is set
04 Mon-Thu 05:00PM off
Switching point 04 is set
05 Fri 03:00PM off
Switching point 05 is set
13. Press the «Right» arrow.
14. Press «Enter».
The
on/off
indicator flashes.
15. Use «Up» or «Down» key to set the action
on
.
16. Press the «Enter» key.
The setting is applied.
The
on
action is set for the first switching point.
17. Set the other switching points in the same manner.
Result Weekdays, time and the actions
on
/
off
are set for all switching points of the user-defined clock
program.
8.5.1.3 Activating the «Time control» key
1. Use «Up» or «Down» to select the
Key time control
line.
2. Press «Enter».
The check box
Key time control
will flash.
4 0 0 m b a r 0 8 : 1 5 A M 8 0 ° C
Header
6 Time control
Menu
Key time control ☑
Active line with deactivated check box
Reset ☐
······························
01 Mon-Fri 06:30AM on
Switching point 01:
02 Mon-Fri 12:00PM off
Switching point 02
03 Mon-Fri 01:00PM on
Switching point 03
3. Press the «Up» key.
The check box is activated.
8 Initial Start-up
8.5 Machine start and machine stop
84
Service Manual Controller
SIGMA CONTROL 2 BLOWER ≥ 2.5.3 No.: 901700 10 E
To Next Page
Loading...
Need help?
General