Keithley 2010 User Manual

SCPI command subsystems reference tables
Table 5-2 through Table 5-11 summarize the commands for each SCPI sub-
system. The following list includes the SCPI subsystem commands and the
table number where each command is summarized.
CALCulate command summary (Table 5-2)
DISPlay command summary (Table 5-3)
FORMat command summary (Table 5-4)
ROUTe command summary (Table 5-5)
SENSe command summary (Table 5-6)
STATus command summary (Table 5-7)
SYSTem command summary (Table 5-8)
TRACe command summary (Table 5-9)
TRIGger command summary (Table 5-10)
UNIT command summary (Table 5-11)
Notes:
• Brackets ([ ]) are used to denote optional character sets. These optional
characters do not have to be included in the program message. Do not use
brackets in the program message.
• Angle brackets (< >) are used to indicate parameter type. Do not use angle
brackets in the program message.
• The Boolean parameter (<b>) is used to enable or disable an instrument
operation. 1 or ON enables the operation, and 0 or OFF disables the
operation.
• Upper case characters indicate the short-form version for each command
word.
• Default Parameter — Listed parameters are both the *RST and
:SYSTem:PRESet defaults, unless noted otherwise. Parameter notes are
located at the end of each table.
• SCPI — A checkmark (√) indicates that the command and its parameters
are SCPI confirmed. An unmarked command indicates that it is non-SCPI.
SCPI confirmed commands that use one or more non-SCPI parameters are
explained by notes.
5-6 SCPI Command Reference

Keithley 2010 Specifications

General

Frequency Range	3 Hz to 300 kHz
DC Voltage Range	100 mV to 1000 V
AC Voltage Range	100 mV to 750 V
DC Current Range	3 A
DC Current Accuracy	0.05%
AC Current Range	3 A
Resistance Accuracy	0.01%
Interface	GPIB, RS-232
Power Supply	50 Hz or 60 Hz