Keithley 2010 User Manual

:ACQuire
:CALCulate[1]:KMATh:PERCent:ACQuire Use input signal as target value
Description This action command is used to acquire the present input signal reading and
use it as the target value for the percent calculation.
:STATe <b>
:CALCulate[1]:STATe <b> Control CALC1
Parameters <b> = 0 or off Disable CALC1 calculation
1 or on Enable CALC1 calculation
Query :STATe? Query state (on or off) of CALC1.
Description This command is used to enable or disable the CALC1 calculation. When
enabled, each instrument reading will reflect the selected calculation (see
:FORMat).
:DATA?
:CALCulate[1]:DATA? Read CALC1 result
Description This query command is used to read the result of the CALC1 calculation. If
CALC1 is disabled or NONE is selected, the “raw” reading will be read.
:CALCulate2
These commands are used to configure and control the CALC2 operations on
readings stored in the buffer.
:FORMat <name>
CALCulate2:FORMat <name> Specify CALC2 format
Parameters <name> = NONE No calculations
MEAN Mean value of readings in buffer
SDEViation Standard deviation of readings in buffer
MAXimum Largest reading in buffer
MINimum Lowest reading in buffer
Query :FORMat? Query programmed math format
Description This command is used to specify the format for the CALC2 math calculation.
The calculation operations for CALC2 use data stored in the buffer.
With NONE selected, no CALC2 calculation is performed. With any of the
other formats selected and CALC2 enabled (see :STATe), the calculation is
performed each time the :IMMediate or :IMMediate? command is executed.
5-22 SCPI Command Reference

Keithley 2010 Specifications

General

Frequency Range	3 Hz to 300 kHz
DC Voltage Range	100 mV to 1000 V
AC Voltage Range	100 mV to 750 V
DC Current Range	3 A
DC Current Accuracy	0.05%
AC Current Range	3 A
Resistance Accuracy	0.01%
Interface	GPIB, RS-232
Power Supply	50 Hz or 60 Hz