Keithley 2010

Description This command is used to specify the format for the CALC1 math
calculations. With NONE selected, no CALC1 calculation is performed.
With MXB or PERCent selected and enabled (see :STATe), the result of the
calculation is displayed. The calculated reading is refreshed each time the
instrument takes a reading.
:KMATh commands
:MMFactor <Nrf>
:CALCulate[1]:KMATh:MMFactor <NRf> Specify “m” factor
Parameter <NRf> = -100e6 to 100e6
Query :MMFactor? Query “m” factor
Description This command is used to define the “m” factor for the mx+b calculation.
:MBFactor <NRf>
:CALCulate[1]:KMATh:MBFactor <NRf> Specify “b” factor
Parameter <NRf> = -100e6 to 100e6
Query :MBFactor? Query “b” factor
Description This command is used to define the “b” factor for the mx+b calculation.
:MUNits
:CALCulate[1]:KMATh:MUNits <name> Specify units for mx+b
Parameter <name> = 2 characters using ‘A’ through ‘Z’
Query :MUNits? Query units for mx+b
Description This command is used to specify the units data element for the mx+b
calculation. Use any two letters from ‘A’ through ‘Z’.
:PERCent <NRf>
:CALCulate[1]:KMATh:PERCent <NRf> Specify target value for percent calculation
Parameter <NRf> = -1e8 to +1e8 Specify target value.
Query :PERCENt? Query percent target value
Description This command is used to specify the target value for the percent calculation.
SCPI Command Reference 5-21