Keithley 2010 User Manual

Thermocouple commands
:TYPE <name>
[:SENSe[1]]:TEMPerature:TCouple:TYPE <name> Specify TC type
Parameters <name> = J Set operation for Type J thermocouples
K Set operation for Type K thermocouples
N Set operation for Type N thermocouples
T Set operation for Type T thermocouples
Query :TYPE? Query thermocouple type
Description This command is used to configure the Model 2010 for the thermocouple
type that you are using to make temperature measurements.
These commands are used to configure the reference junction for
thermocouple temperature measurements.
:RSELect <name>
[:SENSe[1]]:TEMPerature:TCouple:RJUNction[1]:RSELect <name> Specify reference junction type.
Parameters <name> = SIMulated Use simulated temperature as reference
REAL Use a measured temperature as reference
Query :RSELect? Query reference junction type
Description This command is used to specify the type of reference junction that is going
to be used for thermocouple temperature measurements. Specify REAL if
you are using an actual reference junction. The :REAL command is then used
to specify the desired reference temperature. Specify SIMulated if you wish
to use a simulated reference temperature. The :SIMulated command is then
used to specify the desired simulated reference temperature.
:SIMulated <n>
[:SENSe[1]]:TEMPerature:TCouple:RJUNction[1]:SIMulated <n>
Parameters <n> = 0 to 50 Specify temperature in °C
32 to 122 Specify temperature in °F
273 to 323 Specify temperature in K
DEFault 23°C, 73.4°F, 296K
MINimum 0°C, 32°F, 273K
MAXimum 50°C, 122°F, 323K
Query :SIMulated? Query simulated reference
:SIMulated? DEFault Query default *RST reference
:SIMulated? MINimum Query lowest allowable reference
:SIMulated? MAXimum Query largest allowable reference
5-50 SCPI Command Reference

Keithley 2010 Specifications

General

Brand	Keithley
Model	2010
Category	Multimeter
Language	English