5-76 SCPI Command Reference
:SAMPle Command
:SAMPle:COUNt <NRf> Set sample count
Parameter <NRf> = 1 to 1024
Query :COUNt? Query the sample count
Description This command specifies the sample count. The sample count defines how
many times operation loops around in the trigger model to perform a device
action.
NOTE If sample count is >1, you cannot use the :READ? command if
there are readings stored in the buffer.
:UNIT subsystem
The UNIT subsystem is used to configure and control the measurement units
for TEMP, ACV, and DCV, and is summarized in Table 5-11.
:TEMPerature command
:TEMPerature <name>
:UNIT:TEMPerature <name> Specify TEMP units
Parameters <name> = C or CEL °C temperature units
F or FAR °F temperature units
K K temperature units
Query TEMPerature? Query temperature units
Description This command is used to specify the units for temperature measurements.
To Next Page
Loading...
