To Next Page

To Previous Page

Program Fragment

PRINT #1, "output 16; :syst:pres" 'Select defaults

PRINT #1, "output 16; :init:cont off;:abort"

'Place 2010 in idle

PRINT #1, "output 16; :trig:coun 1; sour tim"

PRINT #1, "output 16; :samp:coun 5" 'Program for five measurements

'and stop (idle)

PRINT #1, "output 16; :init; *opc?" 'Start measurements and send

'*opc?

PRINT #1, "enter 16" 'Get response when 2010 goes into

'idle

LINE INPUT #2, a$ 'Read contents of Output Queue

PRINT a$ 'Display the ASCII "1"

*OPT? — Option Identiﬁcation Query Determine if an option is installed

Description

The response message indicates the presence or absence of an optional scanner card. For

example:

0 No scanner card installed

200X-SCAN Scanner card installed

*RCL — Recall Return to setup stored in memory

Parameters

<NRf>=0

Description

Use this command to return the Model 2010 to the conﬁguration stored in memory. The *SAV

command is used to store the setup conﬁguration in memory location.

Only one setup conﬁguration can be saved and recalled.

The Model 2010 ships from the factory with :SYSTen:PRESet defaults loaded into the

available setup memory. If a recall error occurs, the setup memory defaults to the

:SYSTem:PRESet values.

Remote Operation 4-41

Keithley 2010 User Manual

Other manuals for Keithley 2010