System operations
The Model 2010 has other front panel operations. Saving and restoring setup information is
described in Section 2. Selecting the remote interface and language is covered in Section 4.
Self-test
The TEST selections are used as diagnostic tools to isolate problems within the Model 2010.
Information on using these test procedures is included in the Model 2010 Service Manual.
Calibration
The CAL selections are used to view the calibration date and next due date, to perform
calibration, and to view the number of times calibration has been performed. Some of the items
are password-protected to prevent unintended changing of calibration constants.
To view the calibration dates, press SHIFT-CAL. Press ENTER at the DATES prompt. The
first date is the last time calibration was performed. The NDUE date is the calibration due date.
Running calibration is password-protected. Refer to the Model 2010 Service Manual for
details.
To view the calibration count, press ENTER at the COUNT prompt.
3-30 Measurement Options
To Next Page
Loading...
Need help?
General
