:HOLD Command
The following commands are used to configure and control the Hold feature.
For details on Hold, refer to “Trigger Model, Device Action” in this section
and “Hold” in Section 3.
:WINDow <NRf>
[:SENSe[1]]:HOLD:WINDow <NRf> Set Hold window
Parameter <NRf> = 0.01 to 20 Set window (percent)
Query :WINDow? Query Hold window.
Description This command is used to set the window for Hold. The window is expressed
as a percent of the seed reading for the Hold process.
:COUNt <NRf>
[:SENSe[1]]:HOLD:COUNt <NRf> Specify Hold count.
Parameter <NRf> = 2 to 100 Specify Hold count
Query :COUNt? Query Hold count.
Description This command is used to specify the count for Hold. Count is the number of
readings that are compared to the seed reading during the Hold process.
:STATe <b>
[:SENSe[1]]:HOLD:STATe <b> Control (on/off) Hold
Parameters <b> = 0 or OFF Disable Hold
1 or ON Enable Hold
Query :STATe? Query state of Hold.
Description This command is used to enable or disable Hold. See Hold in Section 3 and
Trigger Model, Device Action in this section for details on Hold.
SCPI Command Reference 5-39
To Next Page
Loading...
Need help?
General
