Keithley 2010 User Manual

:STATE <b>
:CALCulate2:STATe <b> Control CALC2
Parameters <b> = 0 or off Disable CALC2 calculation
1 or on Enable CALC2 calculation
Query :STATe? Query state (on or off) of CALC2.
Description This command is used to enable or disable the CALC2 calculation. When en-
abled, the selected CALC2 format will be calculated when the :IMMediate
or :IMMediate? command is executed.
:IMMediate
:CALCulate2:IMMediate Perform CALC2
Query :IMMediate? Perform calculation and read result (equivalent
to :CALCulate2:IMMediate; DATA?)
Description The :IMMediate command is used to perform the selected CALC2 operation
on the readings in the buffer (assuming CALC2 is enabled; see :STATe).
After performing the calculation, the result can be read by using the
:CALCulate2:DATA? query command.
Another way to perform the calculation and read the result is to use the query
form of the command (:IMMediate?). When this command is sent, the
calculation is performed and the result is queried.
Program This example assumes that there are readings stored in the buffer and that
CALC2 is enabled:
PRINT #1, “output 02; :calc2:form max” ‘ Select format
PRINT #1, “output 02; :calc2:imm?” ‘ Perform math and query result
PRINT #1, “enter 02” ‘ Get response from 2010
:DATA?
:CALCulate2:DATA? Read CALC2 result
Description This query command is used to read the result of the CALC2 calculation. If
CALC2 is disabled or NONE is selected, the “raw” reading will be read.
SCPI Command Reference 5-23

Keithley 2010 Specifications

General

Frequency Range	3 Hz to 300 kHz
DC Voltage Range	100 mV to 1000 V
AC Voltage Range	100 mV to 750 V
DC Current Range	3 A
DC Current Accuracy	0.05%
AC Current Range	3 A
Resistance Accuracy	0.01%
Interface	GPIB, RS-232
Power Supply	50 Hz or 60 Hz