G. Apply a light coat of clean engine oil to the
O-ring (6) of the new oil filter cartridge.
H. Install the new oil filter cartridge with an oil
cartridge wrench, and then tighten it to the
specified torque.
111
Make sure the O-ring is seated properly.
NOTE:
Tightening torque:
Oil filter cartridge:
10 N-m (1 kgf-m, 7.2 lbf-ft)
An oil cartridge wrench is available at a nearby
KYMCO dealer
NOTE:
(6)
(5) O-ring
To Next Page
