KYMCO MXU 500 - Troubleshooting

16. BRAKE SYSTEM
16-3
MXU 500
TROUBLESHOOTING
Loose brake lever Tight brake lever
xAir in hydraulic brake system xSeized piston
xBrake fluid level too low xClogged hydraulic brake system
xHydraulic brake system leakage xSmooth or worn brake pad
Poor brake performance Brake noise
xAir in brake system x Contaminated brake pad surface
xDeteriorated brake fluid x Excessive brake disk run out
xContaminated brake pads and brake disk x Incorrectly installed caliper
xWorn brake pads x Brake disk or wheel not aligned
xWorn brake master cylinder piston oil seal
xClogged brake fluid line Hard braking
xDeformed brake disk x Seized hydraulic brake system
xUnevenly worn brake caliper x Seized piston