16. BRAKE SYSTEM
16-37
MXU 500
BRAKE CALIPER
DISASSEMBLY/INSPECTION/
ASSEMBLY
DISASSEMBLY
Remove the front or rear brake caliper (refer
to the “FRONT BRAKE CALIPERS
REMOVAL/INSTALLATION” section or
“REAR BRAKE CALIPERS
REMOVAL/INSTALLATION” section in
this chapter).
Remove the brake pad spring plate.
Remove the piston from the brake caliper.
If necessary, use compressed air to squeeze
out the piston through the brake fluid inlet
opening and place a shop towel under the
caliper to avoid contamination caused by
the removed piston.
Spring Plate
To Next Page
Loading...
