KYMCO MXU 500 - Service Information

6. COOLING SYSTEM
6-2
MXU 500
SERVICE INFORMATION
GENERAL INSTRUCTIONS
WARING:
Removing the radiator cap while the engine is hot can allow the coolant to spray out,
seriously scalding you. Always let the engine and radiator cool down before removing the
radiator cap.
CAUTION:
Radiator coolant is toxic. Keep it away from eyes, mouth, skin and clothes.
xIf any coolant gets in your eyes, rinse them with water and consult a physician immediately.
xIf any coolant in swallowed, induce vomiting, gargle and consult a physician immediately.
xIf any coolant gets on your skin or clothes, rinse thoroughly with plenty of water.
NOTE:
Use coolant with silicate inhibitors may cause premature wear of water pump seals or blockage
of radiator passages. Using tap water may cause engine damage.
xThis section covers service of the cooling system.
xAdd coolant at the reserve tank. Do not remove the radiator cap except to refill or drain the
system.
xAll cooling system services can be done with the engine in the frame.
xAvoid spilling coolant on painted surfaces.
xAfter servicing the system, check for leaks with a cooling system tester.
SPECIFICATIONS
ITEM SPECIFICATIONS
Radiator and engine 2 liter (2.1 US qt, 1.76 lmp qt)Coolant capacity
Reserve tank 0.45 liter (0.47 US qt, 0.39 lmp qt)
Radiator cap relief pressure 90 kPa (0.9 kgf/cm
2
, 12.8 psi)
Begin to open 80 - 84°C (176 - 183°F)
Fully open 95°C (203°F)
Thermostat
Valve lift 8 mm (0.3 in) minimum
Standard coolant concentration 1:1 mixture with soft water