16. BRAKE SYSTEM
16-9
MXU 500
FRONT BRAKE DISCS
REMOVAL/INSPECTION/
INSTALLATION
REMOVAL
Remove the front wheel hub (refer to the
“FRONT WHEEL HUB
REMOVAL/INSPECTION/
INSTALLATION” section in the chapter
14).
Remove the four bolts and then remove the
brake disc.
INSPECTION
Measure the brake disc thickness.
Service Limit: 3 mm (0.12 in)
Measure the brake disk run out.
Service Limit: 0.3 mm (0.012 in)
INSTALLATION
Install the brake disc onto the wheel hub.
Install and tighten the new four bolts to the
specified torque.
Torque: 3.5 kgf-m (35 Nm, 25.2 lbf-ft)
Brake Disc
To Next Page
Loading...
