4. LUBRICATION SYSTEM
4-14
MXU 500
OIL PRESSURE RELIEF VALVE
REMOVAL
Remove the right crankcase (refer to the
“RIGHT CRANKCASE
REMOVAL/INSTALLATION” section in
the chapter 11).
Remove the pressure relief valve and O-ring
from the right crankcase.
INSPECTION
Check the operation of the pressure relief
valve by pushing on the piston.
INSTALLATION
Apply oil to a new O-ring and install the
pressure relief valve groove, and install the
relief valve to the right crankcase.
Oil Pressure Relief Valve
Piston
O-ring
Oil Pressure Relief Valve
To Next Page
