KYMCO MXU 500 - Page 416

11.FINAL REDUCTION/
TRANSMISSION SYSTEM
11-19
MXU 500
Remove the primary drive shaft.
Remove the bolt/washer, then remove the
stopper lever and spring.
INSPECTION
Guide bar
Measure the guide bar runout.
Out of specification ĺ Replace.
Service Limit:
Less than 0.03 mm (0.0012 in)
Primary Drive Shaf
t
Stopper Lever Bolt/Washe
r
Spring
Do not attempt to straighten a bent guide
bar.
＊