KYMCO MXU 500 - Page 653

20. LIGHTS/SWITCHES
20-8
MXU 500
GEAR INDICATOR LIGHT
SWITCHES
INSPECTION
Disconnect the gear indicator light switch
wire connector.
Check for continuity between the switch
side connector terminal and engine ground.
REPLACEMENT
Disconnect the gear indicator light switch
connector.
Remove the bolt, then remove the gear
indicator light switch and washer.
Install the washer and a new switch with a
new O-ring (apply engine oil to O-ring).
Shift the drive select lever to check if the
gear indicator light is correct.
O-ring Washer
Gear Indicator Light Switch Connecto
r
Gear Indicator Light Switch
Make sure that the lever on the gea
r
indicator light switch correctly engages
with the locating slot on the shift shaft.
＊