System Settings
3-3
Accessing the Copy Default Screen
Follow the steps as below to begin changing the default settings.
1
Press the System Menu/Counter key.
2
Press [Copy Default].
3
Use the numeric keys to enter the
four-digit management code. By default,
the management code is 6200 for 62
cpm model and 8200 for 82 cpm model.
The Copy Default screen will be
displayed.
NOTE: For security, it is recommended to change the four-digit management code to any
combination of four digits. Refer to Changing Management Code on page 3-32.
When installing the optional security kit, enter the eight-digit management code. By default, the
management code is 62006200 for 62 cpm model and 82008200 for 82 cpm model.
Proceed to the following sections to customize individual settings.
Density Mode
Density mode changes the default for how the copier adjust how dark or light copying is made.
Choose [Auto] or [Manual] as the default. Selecting [Auto] lets the copier to optimize the density
depending on the original document. Selecting [Manual] allows manual adjustment of density using
the touch panel slider.
1
Access the Copy Default screen. (For instructions, refer to Accessing the Copy Default Screen on
page 3-3.)
2
Press [S] or [T] to select Density Mode
and press [Change #].
To Next Page
Loading...
