Kyocera TASKalfa 620 - Selecting Maximum Number of Copies; Enabling Repeat Copy

System Settings
3-16
3
Press [+] and [-] to specify the widths to
erase the borders.
The range for the width is as follows.
4
Press [Close]. The touch panel will return to the Copy Default screen.
Selecting Maximum Number of Copies
You can limit the maximum number of copies from 1 to 9999.
1
Access the Copy Default screen. (For instructions, refer to Accessing the Copy Default Screen on
page 3-3.)
2
Press [S] or [T] to select Preset limit
and press [Change #].
3
Use the numeric keys to enter the
maximum number of copies from 1 to
9999.
4
Press [Close]. The touch panel will return to the Copy Default screen.
Enabling Repeat Copy
Repeat copy allows the printing of original documents which were copied and stored in the copier.
You can enable or disable repeat copy and set it as the default.
NOTE: This menu is not available when the copier is equipped with the optional security kit.
1
Access the Copy Default screen. (For instructions, refer to Accessing the Copy Default Screen on
page 3-3.)
Default erase width Back
System Menu
Adjust default setting of erase width.
Copy De fault
Gutte rBorder
2)(0
""
¼½
-
2)(0
Setting Range
Inch models 0 to 2" (in 1/8" increments)
Metric models 0 to 50 mm (in 1-mm increments)
System Menu
Copy De fault
Default menu
Au to Image Ro tation
Default margin width
Default erase width
Change #
System Menu / Counter
Se tti ng mod e
Preset limit
Le ft
Border Gutte r
Set
Rotate
¼ " ½ "
¼ "
0 "
Collate/Offset Collate:On/Offset:Off
Preset limit Back
System Menu
Se t output quanti ty.
Copy Default
Set
-