Kyocera TASKalfa 620 - Default Margin; Erasing Borders

System Settings
3-15
Default Margin
Specifies the default margins for copying.
1
Access the Copy Default screen. (For instructions, refer to Accessing the Copy Default Screen on
page 3-3.)
2
Press [S] or [T] to select Default margin
width and press [Change #].
3
Press [S], [T], [W] and [X] to specify
the default margin for each side.
The range for the margins is as follows.
4
Press [Close]. The touch panel will return to the Copy Default screen.
Erasing Borders
Specifies the width for erasing borders.
1
Access the Copy Default screen. (For instructions, refer to Accessing the Copy Default Screen on
page 3-3.)
2
Press [S] or [T] to select Default erase
width and press [Change #].
System Menu
Copy Default
Default menu
Adj. Manual dens.(Photo)
Zoom
Collate/Offset
Change #
Au to Image Rotati on
System Menu / Counter
Setting mode
Default margin width Left
Co l l ate:O n/Offse t:Off
Ro tate
100%
Standard
¼ " 0 "
Default margin width
System Menu Copy Default
Adjust default setting of margin width.
Back
Left
Fro nt p ag e
(0 ¾)
(0 ¾)
"
"
0
¼
-
Setting Range
Inch models 0 to 3/4" (in 1/8" increments)
Metric models 0 to 18 mm (in 1-mm increments)
System Menu
Copy Default
Default menu
Zoom
Collate/Offse t
Au to Image Rotati on
Change #
Default margin width
System Menu / Counter
Setting mode
Default erase width
Le ft
Border Gutter
Collate:On/Offset:Off
Ro tate
100%
¼ " ½ "
¼ " 0 "