Copying Functions
1-57
Programmed Copying
Registers combinations of up to eight copy modes and functions displayed on the operation panel
as a single program. After registering sets of frequently used functions as a single program, you can
simply press the program number as needed to recall those functions. You can also name the
programs to identify them.
Registering Programs
Follow the steps as below to register programs.
1
Access the copy mode to register (e.g., five sets of copies, Collate mode, or Margin mode) and
press [Program].
2
Press [Register].
3
Press a number (1 to 8) for the program
number.
4
Enter the program name and press
[End].
NOTE: For instructions on entering
characters, refer to Entering
Characters on Touch Panel on
page 3-55.
5
Press [Yes] to register the program.
To Next Page
Loading...
